Comments on: Woodworking Projects How to Make a Moxon Vise on the Cheap http://www.onewood.com.au/woodworking-projects-how-to-make-a-moxon-vise-on-the-cheap/ Woodworking education and fun by Warren Downes Tue, 16 Oct 2018 05:47:43 +0000 hourly 1 By: Andrew D http://www.onewood.com.au/woodworking-projects-how-to-make-a-moxon-vise-on-the-cheap/#comment-14443 Tue, 16 Oct 2018 05:47:43 +0000 http://www.onewood.com.au/?p=133#comment-14443 In reply to Dave.

Try looking at scaffolding jacks they use trapezoidal/acme threads and they’re relatively cheap especially if you get them 2nd hand

]]> By: Warren http://www.onewood.com.au/woodworking-projects-how-to-make-a-moxon-vise-on-the-cheap/#comment-12610 Mon, 12 Mar 2018 21:40:37 +0000 http://www.onewood.com.au/?p=133#comment-12610 In reply to Dave.

Hi Dave
I think at the time i found some cheap ones on Ebay with small lengths for sale.

]]> By: Dave http://www.onewood.com.au/woodworking-projects-how-to-make-a-moxon-vise-on-the-cheap/#comment-12584 Sun, 11 Mar 2018 02:09:05 +0000 http://www.onewood.com.au/?p=133#comment-12584 Thanks for this. I want to use Acme threaded bolts but I haven’t found a cheap source for these. Any suggestions? I’m in Brisbane.

]]> By: Warren http://www.onewood.com.au/woodworking-projects-how-to-make-a-moxon-vise-on-the-cheap/#comment-9032 Tue, 07 Mar 2017 22:34:39 +0000 http://www.onewood.com.au/?p=133#comment-9032 In reply to Ken Easton.

Hi Ken
I think i used a 19mm rod and bolt and they were about 300mm-400mm long each. Its not critical for rod thickness anything around that will be fine.

]]> By: Ken Easton http://www.onewood.com.au/woodworking-projects-how-to-make-a-moxon-vise-on-the-cheap/#comment-9030 Tue, 07 Mar 2017 13:52:02 +0000 http://www.onewood.com.au/?p=133#comment-9030 Could you give the bolt sizes and rod length to use pls…and also the bit sizes I’ll need to buy…thanks

]]>